![]() ![]() To connect the Vera directly, get a USB-to-serial adapter and plug it in.Īlternatively, if you have installed an IP-to-serial bridge, set up an IPSerial interface on Vera. Alternatively, if your alarm panel is close to an Ethernet connection, you can connect an IP-to-serial bridge (either a dedicated adapter like the WIZ110SR or a computer running ser2net). You can add a female-to-male straight DB9 serial cable onto the end to make the serial connection as long as you like. The Vera and the Alarm panel might not be in the same room. You still need to cross over the RX/TX pair of wires and to cross over the RTS/CTS pair of wires exactly once this can be done either with a null modem cable or by swapping the jumpers on the NX-8E board (does the NX-8E have jumpers?) or by wiring your DIY cable with the pairs swapped at one end. Third-party 10-pin serial cables might have the same pinout. In some parts of the world Caddx sells a cable with these connections. The NX-8E has a somewhat-standard 2x5-pin serial interface on the main board. The important thing to remember is that you have to cross over the RX and TX wires exactly once, and the CTS and RTS wires exactly once this can be done either with a null modem cable or by swapping the jumpers on the NX-584 board. Use a female-to-female gender changer, and adjust the jumpers on the NX-584/NX-8E board to make it swap RX and TX pins and RTS and CTS pins.Use a female-to-female null modem cable, which swaps RX/TX and CTS/RTS to allow connection to a computer with a serial port, or We want to make it right with you, as you deserve to be completely satisfied with your experience.To connect the interface to another computer, either: ![]() The NX-584 has a male DB9 serial interface. There are many ways of connecting the NX-584/NX-8E panel's serial interface with a serial port on the Vera. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |